Embossed Votive Holder Shade
Create the look of a Stained Glass Votive Holder
Supplies Needed:
Most items can be found in the Scrap booking/Stamping section of your local craft store.
Straight-Sided Clear Glass Votive Holder
Vellum
Craft Markers of various colors
Hole Punch
Decorative String
Embossing Powder in your choice of color
Versamark Ink Pad
Embossing Heat Tool
Scissors
Tape Measure or Ruler
1. Measure the height and circumference of your Glass votive holder with a tape measure or ruler. Use these measurements to cut out a piece of vellum. It is important to make sure that the vellum does not extend past the top of the votive holder because this will increase the risk of a fire hazard.
2. After you have planned your design with your stamp(s), use the Versamark ink to stamp the design onto the vellum. At this point the design will be clear.
3. Now sprinkle the embossing powder onto the stamped design. Turn the vellum upright and make sure all stray powder has been shaken or tapped off. Also make sure that your entire design has been covered in powder. You will be able to see this because the embossing powder will stick to the design that you stamped with the Versamark inkpad.
4. Use - continued below ...
